If you have any problems with the registration process or logging in, please contact us.
Drinking GamesDiscuss, Beer Pong Table at General Discussion forum; I just thought I would post some pictures of a beerpong table that I made. I don't have the ...
I just thought I would post some pictures of a beerpong table that I made. I don't have the dimensions off hand but I'll draw something in cad a little bit later and post it up too. Everyone that has used it loves it. You don't have to worry about the cups falling over, and for those drunk uncoordinated people they don't have to worry about trying to get the cups to line up correctly. It makes some of the reracks a little difficult but we learned to work around it. This particular board is made of MDF which I wouldn't suggest doing because 1.it takes forever to drill through and 2.it's way too heavy.
Alright I attached a drawing of the dimensions that you would need. All you have to do is find the diameter of the top of the cop that you typically use and plug it in for A. That'll give you all the dimensions that you need for marking the spot to drill the hole. You'll need to use a hole saw that is somewhere between the diameter of the top and the diameter of the bottom of the cup, where you measure it at is where it will sit at when placed in the wholes. The blue in the drawing are cups, the white part is just lines showing you where I'm measuring, and the yellow are dimensions that you just have to plug in A for.